A couple of years ago LEGO partnered with Unbound to create a new book, fan chose the subject and the book was crowdfunded shortly after.
A very special and unique piece was listed as one of the pledge stages, here is the first official look at that piece, a 3D printed LEGO Pogo Stick, which can be held by a Minifigure!
A total of 500 elements have been created and the entire thing is 3D printed, just like the recent LEGO Duck piece, including the spring that actually functions.
Take a look below at the prototype and let us know in the comments what you think of it!
What is your reaction?
YES!
23
I like it
6
It's OK
1
Not Sure
0
No!
2
[…] story reported by The Brick Post clarifies that this very special and unique piece was listed as one of the pledge stages. A total […]
Is there anyway to buy these pieces?
Possibly, on the secondary market, for thousands 😩
Someone will likely reverse engineer it and release the STLs sometime in the near future. If you have access to a higher res printer, like SLA/resin, then it’d be pretty easy to print your own.